Messages And Error Messages During Setting Up - Datcon DT9002 Operating Instructions Manual







(4 lines at the bottom of
the display)

(4 lines at the top of the
display)




68

10.6. Messages and error messages during setting up

The following mnemonics may displayed when the settings
are being performed.
The value you have defined is lower than permissible
(Low Limit)
The instrument has replaced the value you have defined to
the permitted lowest value.
The value you have defined is higher than permissible
(High Limit)
The instrument has replaced the value you have defined to
the permitted highest value.
.
Exit from the menu, returning to the normal operating
mode (Exit)
Saving the changed parameters is being done (Save)
Low numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit" to the display
format.
High numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit" to the display
format.
The instrument is performing internal operations (Busy)
The requested task has been successfully completed
(Ready)
I do not want this menu item (No)
Yes, the menu item may be started (Yes)
DT9002
20180621-V1