Datcon DT9002 Operating Instructions Manual page 31

DT9002
Setting the operating
mode
Sequence of operations
Setting the operating
mode
Sequence of operations
20180621-V1
5. Keep stepping by pressing the ▲ button you can select
the desired limit-output operating mode.

•
 : the output is always in switched off condition.
[default factory setting]

•
 : (≥L) The output gets switched on, when the
displayed physical value is higher than or equal with the low
limit value (LL).

•
 : (<L) The output gets switched on, when the
displayed physical value is lower than the low limit value
(LL).

•
 : (≥L and ≤H) The output gets switched on, when
the displayed physical value is between the low limit value
(LL) and the higher limit value (HL).

•
 : (<L or >H) The output gets switched on, when
the displayed physical value isn't between the low limit
value (LL) and the high limit value (HL).

•
 : the output is always in switched on condition
6. After you have selected the desired operating mode for
the limit output, press the MENU button. This takes you out
from the given sub-menu item, and you see this:
7. If you had selected the
need to do any further settings. For finishing the operation,
please go on from the point Exit from the menu item.
 
or the mode, there is no

.
31