Low limit value
Sequence of operations
32
8. Keep stepping by pressing the ▲ button as long as you
see this sub-menu item:
low limit value. Here you can define the numerical value by
which the device will compare the measured physical
values.
9. Enter by pressing the ENTER button.
10. You see this
is blinking in the upper left corner. The arrow indicates that
the uppermost digit (the „half" digit) is being selected from
the 4 and half digits, and now it can be modified by pressing
the ▲ button.
11. Pressing the ▲ button you can switch on or off the „half"
digit, or you can type in the value 20.000.
•
= 10.000
•
= 20.000
•
= 0.000
12. Pressing the ► button you can select the next digit.
13. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
14. When the last digit (right-side) is being selected, and
you press the button ►, a blinking colon appears on the left
side:
. The colon indicates that the plus/minus
sign is being selected, and it can be modified by pressing
the ▲ button.
15. Pressing the ▲ button you can switch on or off the
minus sign.
•
= 10.000
•
= -10.000
16. After you have defined the value for the limit, press the
MENU button to exit from the sub-menu item, and you see
this:
.
. LL (Low Limit) means: the
on the display and the arrow (
,
,
,
,
,
DT9002
←
, etc.
20180621-V1
)