Table of Contents
Advertisement
DT4240 xx xx xx xx
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
20230503-V0
7.18. Resetting the default settings (21. menu item)
In this case all the settings are deleted, and the default
factory setting is restored.
Using this function makes sense in that case, when the
settings of the instrument have changed so much, that it is
easier to start the setting-up process from the default
factory setting.
It is not possible to cancel this operation once the command
has been issued.
The way the code should be type in is described in Chapter
7.1. Typing the code in.
You see this on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
settings).
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic
mnemonic is blinking signaling that it can be modify.
5. Now you still have the possibility to exit. If you want to
exit, as you do not want to reset the default settings after all,
press the MENU button. This takes you out from this menu
item, and you see this:
6. Press the ▲ button to set
7. Press the ENTER button you see this
ready) on the display. All of the parameters have been set
to factory default settings.
After then it restarts:
,
.
Factory defaults: voltage transformer ratio UX = 1, output
current = 4-20 mA, limit outputs are in off state, MODBUS
modul address = 0 (disable), etc..
(Default settings = default
is shown on the display. The
.
.
.
(Ready =
61
Advertisement
Table of Contents
