Siruba 700KST Instruction Book page 13

4. 馬達啟動踏板①裝於左邊，押具腳踏板②則
裝於右邊。( 圖 8)
本體與車板不得干涉
5. 注意馬達之轉向為順時鐘方向，皮帶①之鬆
緊度以用手指向內壓下縮 10mm 之緊度為
宜。( 圖 9)
6. 確保使用者的安全一定要鎖上皮帶護蓋②。
( 圖 9)
4.Install the motor activating plate ① to the
left, and the presser pedal ② to the right.
(Fig.8)
5.Pay attention to the motor rotation which
should be clockwise. The slackness of the
belt ① should be 10mm pressed down by
the finger.(Fig.9)
6.For the operators´ safety , be sure to lock up
the belt cover ②.(Fig.9)
①
皮帶輪
Pulley
Introduction
圖 8 / Fig. 8
②
圖 9 / Fig. 9
P7