Replace The Needle - Siruba 700KST Instruction Book

換針方法
1. 使用 DCX27 或同規格之針。
2. 旋開螺絲①並取下針。
3. 將新針插至針孔最底端，並使針之長溝面向
自己，固定螺絲①。( 圖 17)
針距調整
通常依縫合布料，差動比等之不同而調整。持
續壓下按鈕①並轉動手輪使鈕卡住，轉動手輪
至所需之針距後放開此按鈕。( 表 2)( 圖 18)

REPLACE THE NEEDLE

1.Please use the needle DCX27 or the
equivalents.
2.Loosen the screw ① and take off the needle.
3.Insert the new needle till reaching the end,
as well as the long groove faces your side.
Tighten the screw ①. (Fig.17)
ADJUST THE STITCH LENGTH
The stitch length is adjusted according to the
fabrics, the differential ratio or other factors.
Keep pressing the button ① and turn the
pulley till the button is locked. Then, release
the button after reaching the desired stitch
length.(Table2)(Fig.18)
Introduction
①
圖 17 / Fig. 17
P13