Siruba 700KST Instruction Book page 18

2. 針線控線關係 ( 圖 15)
(1) 縫合方式 504、505、514 時，將過線組件
①移至最下端。
(2) + 表示增加針線放線量。
(3) － 表示減少針線放線量。
3. 勾針控線關係 ( 圖 16)
(1) 若縫合方式為 504 ，514 及上勾針移至最
低時，將①往 + 位置微調。若縫合方式為
505 時，則往 － 端微調。
(2) 固定線導板②、③如下：+ 方向為縫合線
較多，反之較少。
P12
2.Relation of needle thread tension (Fig.15)
(1)While doing the stitches, 504,505,514, move
the eyelet ① to the bottom.
(2) + indicates to increase the thread amount.
(3) － indicates to decrease the thread
amount.
3.Looper thread control(Fig.16)
(1)When the sewing type is 504, 514, and
the upper looper is on the lowest point,
adjust ① at the position of + . When the
sewing type is 505, set the take-up ① at the
position of － .
(2)Adjust fixed thread guide plate ② and ③ as
the following: The direction + is for more
thread in sewing seam, and the － direction
is for less thread in sewing seam.
圖 15 / Fig. 15
圖 16 / Fig. 16