Wireless Network Settings - Yealink SIP-T48S User Manual

User Guide for the SIP-T48S IP Phone
To configure a static IPv6 address via phone user interface:
Tap ->Advanced (default password: admin) ->Network->WAN Port->IPv6.
1.
Tap the gray box of the Type field, and then select Static IP from the pull-down list.
2.
Enter the desired value in the IP Address, IPv6 IP Prefix, Default Gateway, Pri.DNS and
3.
Sec.DNS field respectively.
Tap the Save soft key to accept the change or
4.
Note The wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters, contact your
system administrator.

Wireless Network Settings

Wi-Fi is a popular wireless networking technology that uses radio waves to provide wireless
high-speed Internet and network connections. You can activate/deactivate the Wi-Fi mode on
the IP phone, and then connect your phone to the desired wireless network.
Note
Ensure that the Wi-Fi USB Dongle WF40 is properly connected to the USB port at the back of the
IP phone. For more information, refer to
26
to cancel.
Phone Installation on page 18.