Hints For Using; Maintenance - Dog trace d–control 640 User Manual

Hints for using

Do not place your remote controller close to objects sensitive to magnetic fi elds that
might get damaged and be out of repair.
Do not put your d–control in places exposed to high temperatures.
It is necessary to replace the batteries every two years and also in the case that the set
is not used for a long time. Never leave a fl at battery in your unit; it might leak and
damage your unit.

Maintenance

Never use volatile agents such as thinners, petrol, or various cleaners to clean your
DOGtrace™ d–control. Use a soft damped cloth and a neutral clearing agent if necessary.
The receiver (collar) DOGtrace™ d–control is water-tight only on condition of a good
state of the seal and after its treatment with silicone vaseline. If this is fulfi lled, your dog
can even swim with that. In order to maintain the water-tightness of your receiver, we
recommend to replace the rubber seal under the receiver's cover and treat it with silicone
vaseline.
After every replacement of the battery in the collar, make sure that the seal is properly
cleaned and settled and that the screws are adequately tightened. Check them regularly
and tighten them only adequately!
The remote controller is dustproof and moisture resistant! It is defi nitely not suitable to
expose it to rain or spraying water. Protect it against water and moisture however it is
possible. If it is dropped into water, it will certainly be irrecoverably damaged
or destroyed.
If you do not use the unit for a long time, remove the batteries from your remote controller
and receiver.
The collar will remember the preset confi guration (auto encoding). When you turn it on next
time, it will be in the mode you selected last time.
17