Turning On/Off - Dog trace d–control 640 User Manual

Hide thumbs Also See for d–control 640:
Table of Contents

Advertisement

Turning ON/OFF

TURNING THE REMOTE CONTROLLER ON/OFF
Turning on: Press down the
Turning on is indicated by lighting up of the LCD display.
Switching off : Again, press down the
Turning off is indicated by going out of the LCD display.
TURNING THE RECEIVER (COLLAR) ON/OFF
A magnetic switching system located in the remote controller is used to turn the receiver
(collar) on and off .
Turning on: Place the lower part of the remote controller for 1 second to the target
on the receiver (refer to the Fig.). The receiver indicator will start blinking in green and this
indicates that the receiver is ready for use.
Turning off : Again, place the lower part of the remote controller for 1 second to the
target on the receiver (see the Fig.). The LED indicator of the receiver will be lit red.
The receiver is turned off .
CAUTION: To save the battery life time, it is
necessary to switch off both transmitter and
receiver after training!!! If you do not use the
device for a longer time period, it is recommended
to remove the batteries.
and the transmitter is being matched with the receiver
8
On/Off button on the remote controller for 1 second.
The situation when the receiver is turned on/off
On/Off button for 1 second.

Advertisement

Table of Contents
loading

Table of Contents