Table of Contents
Advertisement
REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint either using the same remote
controller or with another (see the section Programming /matching/ of your remote controller
and receiver).
ADVICE: It is possible to program an unlimited number of receivers to one transmit-
ter, which is possible to use for training of several dogs at the same time.
It is possible to record two transmitters into one receiver, which can be used,
for instance, for a potential correction of the dog's training by an instructor.
How to use the remote controller
The DOGtrace™ d–control remoter controller is designed for cooperation with two separate
receivers independent of each other (dog 1 or 2 selection).
Button
– Sound signal
When you press down the sound signal button, you will be able to send the sound signal to
your receiver at a long distance. There is no time limit for this function: The buzzer will sound
for as long as you are holding the pressed down button and the green LED on your receiver
will be permanently lit.
It will be indicated by the transmission symbol on the LCD display of your remote controller.
Button
– Vibration
By pressing this button, you will send a warning to your dog in the form of vibration.
There are 5 modes of vibration available.
Mode
Function
0
short pressing – short vibration
1
long pressing – vibrates as long as you keep the button pressed
2
short pressing – series of interrupted vibrations
3
long pressing – vibrates interruptedly as long as you keep the button pressed
4
permanent pressing – vibrates permanently and releases a sound signal
10
Advertisement
Table of Contents
