3-5.2.5 Arp Inspection - Vivotek AW-GEV-264A Series User Manual

3-5.2.5 ARP Inspection

The section describes to configure the ARP Inspection parameters of the switch. You could
use the ARP Inspection configure to manage the ARP table.
3-5.2.5.1 Configuration
This section describes how to configure ARP Inspection setting including：
Mode (Enabled and Disabled)
Port (Enabled and Disabled)
Web Interface
To configure an ARP Inspection Configuration in the web interface:
1. Select "Enabled" in the Mode of ARP Inspection Configuration.
2. Select "Enabled" of the specific port in the Mode of Port Mode Configuration.
3. Click Apply.
Figure 3-4.2.6.1: The ARP Inspection Configuration
Parameter description:
Mode of ARP Inspection Configuration :

Enable the Global ARP Inspection or disable the Global ARP Inspection.
Port Mode Configuration :

Specify ARP Inspection is enabled on which ports. Only when both Global Mode and Port
Mode on a given port are enabled, ARP Inspection is enabled on this given port. Possible
modes are:
Enabled: Enable ARP Inspection operation.
Disabled: Disable ARP Inspection operation.
If you want to inspect the VLAN configuration, you have to enable the setting of "Check
User Manual rev. 1.2. Aug. 2015
87