4-5.1.3 Arp Inspection - Vivotek AW-GEV-264A Series User Manual

4-5.1.3 ARP Inspection

The section describes to configure the Dynamic ARP Inspection Table parameters of the
switch. The Dynamic ARP Inspection Table contains up to 1024 entries, and is sorted first by
port, then by VLAN ID, then by MAC address, and then by IP address.
Web Interface
To configure a Dynamic ARP Inspection Table Configuration in the web interface:
1. Click Security, Network, ARP Inspection.
Checked "Auto-refresh".
2.
3. Click " Refresh" to refresh the port detailed statistics.
4. Specify the Start from port, VLAN ID, MAC Address, IP Address, and entries per page.
.
Figure 4-5.1.3: The Dynamic ARP Inspection Table
Parameter description:
Navigating the ARP Inspection Table :
Each page shows up to 99 entries from the Dynamic ARP Inspection table, default being 20, selected
through the "entries per page" input field. When first visited, the web page will show the first 20 entries
from the beginning of the Dynamic ARP Inspection Table.
The "Start from port address", "VLAN", "MAC address" and "IP address" input fields allow the user to
select the starting point in the Dynamic ARP Inspection Table. Clicking the button will update the
displayed table starting from that or the closest next Dynamic ARP Inspection Table match. In addition,
the two input fields will - upon a button click - assume the value of the first displayed entry, allowing for
continuous refresh with the same start address.
The will use the last entry of the currently displayed table as a basis for the next lookup. When the end
is reached the text "No more entries" is shown in the displayed table. Use the button to start over.
Port :

Switch Port Number for which the entries are displayed.
VLAN ID :

VLAN-ID in which the ARP traffic is permitted.
MAC Address :

User MAC address of the entry.
IP Address :

User IP address of the entry.
Buttons

User Manual rev. 1.2. Aug. 2015
221