Loop Protection - Vivotek AW-GEV-264A Series User Manual

4-7 Loop Protection

This section displays the loop protection port status the ports of the currently selected switch.
Web Interface
To display the Loop Protection status in the web interface:
1. Click Monitor, Loop Protection
2. If you want to auto-refresh the information then you need to evoke the "Auto refresh".
3. Click " Refresh" to refresh the LACP Statistics.
Figure 4-7: Loop Protection Status
Parameter description:
Port

The switch port number of the logical port.
Action

The currently configured port action.
Transmit

The currently configured port transmit mode.
Loops

The number of loops detected on this port.
Status

The current loop protection status of the port.
Loop

Whether a loop is currently detected on the port.
Time of Last Loop

The time of the last loop event detected.
Buttons

Refresh: Click to refresh the page immediately.
Auto-refresh: Check this box to enable an automatic refresh of the page at
regular intervals.
User Manual rev. 1.2. Aug. 2015
244