Table of Contents
Advertisement
3-13 VLANs
To assign a specific VLAN for management purpose. The management VLAN is used to
establish an IP connection to the switch from a workstation connected to a port in the VLAN.
This connection supports a VSM, SNMPsession. By default, the active management VLAN is
VLAN 1, but you can designate any VLAN as the management VLAN using the Management
VLAN window. Only one management VLAN can be active at a time.
When you specify a new management VLAN, your HTTP connection to the old management
VLAN is lost. For this reason, you should have a connection between your management
station and a port in the new management VLAN or connect to the new management VLAN
through a multi-VLAN route
Web Interface
To configure VLAN membership configuration in the web interface:
1.
Click Configuration VLANS.
2.
Specify Existiong VLANs, Ethertype for Custom S-ports
3.
Click Apply.
Figure 3-13.1: The VLAN Configuration
Parameter description:
Global VLAN Configuration
Existing VLANs :
This field shows the VLANs that are created on the switch.
By default, only VLAN 1 exists. More VLANs may be created by using a list syntax where
the individual elements are separated by commas. Ranges are specified with a dash
separating the lower and upper bound.
The following example will create VLANs 1, 10, 11, 12, 13, 200, and 300: 1,10-13,200,300.
User Manual rev. 1.2. Aug. 2015
137
Advertisement
Table of Contents
