Crestron Isys i/O TPMC-15-CH Operation Manual page 20

Touchpanel Media Centers
16 Touchpanel Media Centers: Crestron Isys i/O™ TPMC-15/17 Tilt Series
Crestron Isys i/O
Reader/Writer have been tested), USB mice (Gyration Ultra GT Cordless Optical
Mouse, Belkin, and Logitech USB mice have been tested) and keyboards. Additional
functionality/compatibility will be available in future firmware releases.
USB Type A Connector Pinout
PIN DESCRIPTION
1 +5 VDC
2 Data -
3 Data +
4 Ground
NOTE: Only standard Windows
load your own driver.
NOTE: The maximum length for a USB cable run is 16.4 feet (5.0 meters)
PWR
This female connector is used to supply 12 VDC power to the touchpanel from the
included external power pack.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
PHONE
Connect this standard mini phone jack (105 mW per channel, 8 ohm load) to the plug
of an external headphone set, not supplied.
PC CARD
Two Type II PCMCIA Card slots used for memory expansion up to 4GB or more,
VT Pro-e project uploads, or installation of a wireless network card. A cover is
secured over the slots to protect the electronics. Use a #1 Phillips screwdriver to
remove the cover. The plate can be flipped and secured if only one slot needs to be
accessed.
CAUTION: PCMCIA cards should be installed face down.
NET
The four-position mini-terminal block connector provides communication with a
Cresnet control network using three of the connecting pins. For additional details,
refer to "Network Wiring" on page 21.
NOTE: The TPMC-15 and TPMC-17 do not use, or supply power to the 24 VDC
Cresnet connection.
™
TPMC-15/17 Tilt Series
Pins 1 2 3
®
XP embedded drivers are included. You cannot
Operations Guide - DOC. 6344
4