Fuji Xerox ApeosPort-IV C4430 User Manual page 76

3 Copy
Preset %
Select a copy ratio from the following options.
100%
Copies at the same image size as the original document.
Auto %
Automatically determines the copy ratio based on the document size and the paper
size specified in [Paper Supply], and copies the document to fit into the paper.
Note
Preset ratios
Select from the preset ratios.
You can change the copy ratio associated with each button. For information on the settings, refer to "5
Tools" > "Copy Service Settings" > "Reduce/Enlarge Presets" in the Administrator Guide.
Slight Reduction (Improves Fit)
Select this check box to slightly reduce the specified copy ratio to copy the complete
image onto the paper.
3
Important • If you select [Slight Reduction (Improves Fit)] and you do not want to erase the edges of the
When [Independent X - Y%] is Selected
You can specify reduction/enlargement ratios for the width and length individually.
1
Select any option.
Variable %
Width - X%, Length -Y%
Allows you to specify reduction/enlargement ratios for the width and length in the
range from 25 to 400% in 1% increments. Use [+] and [-] or the numeric keypad to
specify a ratio.
Lock X - Y%
Allows you to make the same ratio adjustment for the width and length at the same
time.
Preset %
Width: 100% /Length: 100%
Copies at the same image size as the original document.
Auto X - Y%
Automatically determines the reduction/enlargement ratios for the width and length
so that the document image fits in the paper.
76
• If you select [Auto %], an option other than [Auto Select] is selected in [Paper Supply].
document, set the amount of edge erase to 0 mm. Note that if the amount is set to 0 mm, the
edges of the copied document may get dirty. You can set [Edge Erase] on the [Layout
Adjustment] screen. For more information, refer to"Edge Erase (Erasing Edges and Margin
Shadows of the Document)" (P.100).