Fuji Xerox ApeosPort-IV C4430 User Manual page 138

3 Copy
Delete Outside
Deletes the outside of the selected area.
Delete Inside
Deletes the inside of the selected area.
Area Settings
Displays the [Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] screen. You can
specify up to three areas.
Refer to "[Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] Screen" (P.138).
Originals
When the original document is a 2-sided document, specify from which side the
specified area is to be deleted.
Both Sides
Applies the settings to both sides of the document.
Side 1 Only
3
Applies the settings to Side 1 of the document.
Side 2 Only
Applies the settings to Side 2 of the document.
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify
the top of the document.
Note
Upright Images
Select this option when placing the top edge of the document against the top side of
the document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of
the document glass or document feeder.
[Delete Outside/Delete Inside - Area 1 (Area 2 or Area 3)] Screen
This screen allows you to specify the area to be deleted. The area is defined by the
rectangle formed between the points X1,Y1 and X2,Y2. The origin point is the top right
corner of a document.
You can specify a value in the range from 0 to 356mm for the width (X) and the length
(Y) in 1 mm increments.
Note
138
• If the [Original Orientation] setting differs from the actual document orientation, the machine
may not detect the top of the document correctly.
• Specify the 2 coordinates from the top right corner of the document.
• When specifying multiple areas, the specified areas can overlap each other.
• When [Reduce/Enlarge] is set, the specified area will be reduced or enlarged accordingly.