Change Of Parking Brake Cable And Adjustment Of; Cable Tension - PRONAR T023 Manual

SECTION 5
IMPORTANT!
The positions for fixing the brake cylinder in the bracket openings and the brake
cylinder pin in the expander arm are determined by the Manufacturer and must
not be changed.
Each time when dismantling the pin or brake cylinder, the original fixing position
should be marked.

5.2.8 CHANGE OF PARKING BRAKE CABLE AND ADJUSTMENT OF

CABLE TENSION.

Proper operation of the parking brake is dependent on the effectiveness of the axle brake
and the correct brake cable tension.
Replacing the parking brake cable
FIGURE 5.9 Installing the parking brake cable
(1) U-bolt clamp, (2) nuts of clamps, (3) handbrake cable
PRONAR T023, PRONAR T023M
5.15