Inspection Of The System; Cleaning The Air Filters - PRONAR T023 Manual

SECTION 5 PRONAR T023, PRONAR T023M

5.3.3 INSPECTION OF THE SYSTEM

During tightness inspection attention should additionally be given to technical condition and
degree of cleanness of the system components. Contact of pneumatic conduit seals etc. with
oil, grease, petrol etc. may cause damage and accelerate the ageing process. Bent,
permanently deformed, cut or worn conduits should be replaced.
INSPECTION
• Each time during tightness inspection.

5.4 CLEANING THE AIR FILTERS

Depending on trailer working conditions, but not less than once in three months, take out and
clean air filter inserts, which are located in pneumatic system connection conduits. Inserts are
used many times and are not subject to changing unless they are mechanically damaged.
FIGURE 5.10 Air filter
(1) securing slide lock, (2) air filter cover
5.19