Consumables - PRONAR T023 Manual

PRONAR T023, PRONAR T023M
TIP
Number of lubrication points and subassemblies requiring lubrication specified
in table (5.3) LUBRICATION SCHEDULE depend on the trailer version.
Locations of grease nipples and areas requiring lubrication are indicated by
black arrows in figure (5.12).

5.6.1 CONSUMABLES

Hydraulic oil:
Always adhere to the principle that the oil in the trailer hydraulic system and in the tractor
hydraulic system are of the same type. In the event of application of different types of oil
make certain that both hydraulic substances may be mixed together. Application of different
oil types may cause damage to trailer or tractor. In a new machine, the hydraulic system is
filled with L HL32 Lotos hydraulic oil.
In the event of necessity of changing hydraulic oil for another oil, check the recommendations
of the oil Manufacturer very carefully. If it is recommended to flush the system with the
appropriate preparation, then comply with these recommendations. Attention should be
given, so that chemical substances used for this purpose do not damage the materials of the
hydraulic system. During normal trailer use, change of hydraulic oil is not necessary, but if
required, this operation should be entrusted to a specialist service point.
TABLE 5.5 L-HL 32 Lotos hydraulic oil characteristics
ITEM
1 ISO 3448VG viscosity classification
2 Kinematic viscosity at 40°C
3 ISO 6743/99 quality classification
4 DIN 51502 quality classification
5 Flash-point
Because of its composition the oil applied is not classified as a dangerous substance,
however long-term action on the skin or eyes may cause irritation. In the event of contact of
NAME
5.28
SECTION 5
UNIT VALUE
- 32
2
mm /s 28.8 – 35.2
- HL
- HL
C 230