Replacement Of Parking Brake Cable And Adjustment Of Cable Tension - PRONAR PT610 Operator's Manual

Pronar PT610
each other at full braking. If this is not so, adjust the position of the lever, which has the
longer stroke.
During dismantling of cylinder fork remember or mark the original setting of the cylinder fork
pin (L1 distance - front axle, L2 distance - rear axle). The mounting position is selected by the
Manufacturer and may not be changed.
5.2.9 REPLACEMENT OF PARKING BRAKE CABLE AND ADJUSTMENT OF
CABLE TENSION.
Proper operation of the parking brake is dependent on the effectiveness of the rear axle
brake and the correct brake cable tension.
FIGURE 5.6 Adjustment of parking brake cable tension
(1) brake crank mechanism, (2) hand brake cable, L=900 mm, (3) hand brake cable,
L= 2,000 mm, (4) shackle, (5) u-bolt clamp, (6) clamp nuts, (7) pulley block
5.14
SECTION 5