ABB DPU 1500R Instruction Book page 65

9/99
When you have verified that the location and file name are correct, click Save.
When the file save has finished, you may either choose another record to save (repeat the above steps) or click Cancel
to end the Export Oscillographics process.
d. Program Curves - When the Save As dialog appears, choose the location where you would like to have the file
stored. Assign a name to the file and click Save.
When the User dialog appears, select either User1, User2 or User3 and click OK.
Import
1. Select File, Import.
2. Select Program Curves.
3. When the Open dialog appears, select the file you wish to import to the relay and click Open.
4. When the User dialog appears, select either User1, User2, or User3 and click OK.
5. When the Password dialog appears, enter the correct password and click OK.
Oscillographics Analysis Tool
To run the Oscillographics Analysis Tool program, click Osc. Analysis Tool.
NOTE: If you chose not to install Oscillographics Analysis Tool at the time of the initial WinECP installation, you will not
be able to access the Oscillographics Analysis Tool software.
FPI
To run the FPI program, click FPI.
NOTE: If you chose not to install FPI at the time of the initial WinECP installation, you will not be able to access the FPI
software.
CAUTION!! Settings saved in the FPI application are not compatible with the WinECP application. You must use
WinECP if you wish to save all your Settings prior to downloading new firmware.
Exit
To quit the WinECP application, click Exit.
EDIT
The "Edit" Menu item allows you to copy and paste settings from the Alternate 1, Alternate 2, and Primary settings
screens. The copy and paste functions work only with these settings screens, permitting you to copy settings from one
screen to another (e.g., from Primary to Alternate 1 or Alternate 2).
NOTE: The copy and paste functions are only enabled when working in the Alternate 1, Alternate 2, and Primary settings
screens. They are disabled when you are working on any other settings screen. The "paste" function is enabled only if
you have previously selected to "copy" settings from one of these three settings screens.
Interfacing with the Relay
ABB Distribution Protection Unit 1500R
website:www.abb.com/papd
5-11