Branson Sonifier SLPt User Manual page 39

SLPt Cell Disruptor
User Manual
1 Digital LED Display: Displays parameters. All parameters to be set are viewed on this display.
2
Mode: Selects and advances Mode selection.
3 Set: Sets parameter values for selected Mode.
4
Reset: Resets an alarm.
5
Test: Sets up resonant frequency. This key is only active when the system is ready. Pressing Test will
store function causing the power supply module to test for the resonant frequency of the stack
at 10% amplitude for a predetermined time.
While in Test mode, the Mode LED's will be off, the Amplitude LED will be on and the lower
colon will be blinking. When completed, the Mode LED's will be restored, the amplitude LED
6
Enter: Confirms a selection setting. This includes the configuration menu.
7 Stop/Start: Starts or Aborts a cycle. Set up in Configuration menu to either a Pulse Start = 0 (Press
8
Left Arrow: Indexes active digit right to left. The digit will blink to indicate it is ready to modify.
9
Up Arrow: Increments the selected digit, one count per key press, at an increment appropriate for the
100-214-252 Rev. A
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
During a weld cycle, % Peak Power is displayed, and the lower 1A and upper half
1B of a colon will blink respectively to indicate sonics on and off.
While in Test mode, the lower half 1A of the colon will be blinking.
2A Continuous Mode
2B Time Mode, minutes/seconds
2C Time Mode, hours/minutes
2D Energy Mod
2E Pulse Mode
Time On LOW from 1 second to 99minutes: 59 seconds.
Time On HIGH from 1 minute to 99 hours: 59 minutes.
Off Time from 1 sec to 99 minutes: 59 sec.
Amplitude from 10% to 100%.
Experiment Time from 1 minute to 99 hours: 59 minutes.
Time On LOW, Pulse/ Experiment from 1 second to 99minutes: 59 seconds.
Time On HIGH, Pulse/ Experiment from 1 minute to 99 hours: 59 minutes
Set Pulse/ Experiment from 1 to 9999 Joules.
Pressing Reset during parameter entry will restore the original value to the parameter
being modified and then return the system to ready. At this time the power supply is
also reset and cleared of any alarms.
turn on sonics and hold them on until the key is released. Test performs run, seek and
and blinking half colon will be off.
and hold to run a cycle) or Pulse Start = 1(Press and release to run a cycle).
When in Configuration Mode, it selects functions.
parameter selected.
When in the Configuration Menu, this key toggles the function between Off (0), and On
(1).
Chapter 6: Operation
Front Panel Controls
6-3