System Features - Branson Sonifier SLPt User Manual

Chapter 2: Introduction to the SLPt Cell Disruptor

System Features

2.3 System Features
The SLPt Cell Disruptor includes the following features:
• Front-panel system On/Off switch
• Separate front-panel Stop and Pause buttons for experiment cycles
• Power output of up to 150 Watts.
• 92 - 132 Volt and 180 - 253 Volt models available (factory set)
• Front-panel LED display, showing parameter settings, alarms and messages
• Membrane front panel with numeric keypad for parameter entry and function selection
• Digital parameter setting, with valid parameter range checking
• Pulse or Continuous operation
• Digital Timer
• Automatic end-of-cycle audible alarm
• Factory-tuned 40 kHz ultrasonic design, requires no user adjustment
• User External Input, provides ability to remote start, seek and overload Alarm Reset. Also can monitor
Weld On, Ready and Alarm
For additional feature information, please contact your Branson representative.
2-6
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
100-214-252 Rev. A