Connecting Microtips, And Converters - Branson Sonifier SLPt User Manual

SLPt Cell Disruptor
User Manual

4.4.2 Connecting Microtips, and Converters

Connecting the Microtip to the Converter
To connect the microtip to the converter, take the following steps:
Step
Clean the contacting surfaces of the converter and microtip, and remove
1
any foreign matter from the threaded stud and threaded hole.
Thread the horn stud into the converter and tighten, using wrenches. The
2
recommended torque is 220 inch-pounds (24.85 Nm).
CAUTION
!
The tip must be installed clean and dry, or the power supply may not tune and operate
correctly.
100-214-252 Rev. A
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
Chapter 4: Installation and Setup
Assembling the Equipment
Action
4-7