Table of Contents
Advertisement
dc_BA.boo Seite 214 Mittwoch, 20. Mai 2009 10:17 10
Operation
Tyres and wheels
Calling up tyre pressure using the on-
board computer
Switch on the ignition.
Check that you can see the standard
display in the right-hand multi-function
display ( page 117).
Press the ƒ or ‚ button repeat-
edly until you see the current pressure
of each tyre in the right-hand
multi-function display.
214
i
If you have only just activated the tyre pres-
sure monitoring system, the current tyre pres-
sure values are only displayed after you have
been driving for a few minutes.
Tyre pressure displayed only after
driving for a few minutes
appears in the multi-function display.
i
The tyre pressures indicated in the on-board
computer may differ from those measured at a
filling station with a pressure gauge. The
on-board computer will give more accurate val-
ues.
Restarting the tyre pressure monitoring
system
The tyre pressure monitoring system must
be restarted if:
you have changed the tyre pressure
you have changed the tyres or wheels
you have fitted new tyres or wheels
Make sure that the pressure in all four
tyres is set correctly using the table on
the door sill of the passenger side.
Also observe the notes in the section
on tyre pressures ( page 212).
Advertisement
Table of Contents
