Table of Contents
Advertisement
Timed
Exposure Mode
Trigger Width
Exposure Auto
Auto Exposure Response Speed
Video Send mode
Digital I/O
Ref. level
Video level adj. range
Black Level Adjust.
Adj. range
Resolution
Analog Base Gain (For manual)
Manual
Gain Control
Gain Auto
Detection
Blemish
Compensation
Comp.
Numbers
ALC
Gamma
Dark compression
LUT
HDR
6-Pin
Connector
Power
PoE
Lens mount
Flange back
Optical filter
Operating temperature/Humidity Performance guaranteed
Storage Temp. / Humidity
Regulation
Housing Dimensions
Weight
Note1): Usable performance will be up to 1 second.
Note2): A minimum of +12dB of gain can be applied without causing any breaks in the histogram.
Note3): Approximately 5 minutes pre-heating is required to achieve these specifications.
Note4): The above specifications are subject to change without notice.
Exposure Auto: OFF 10 μs (Min.)～ 8 second (Max.) (Note1),
Variable unit: 1 μs
Exposure Auto: Continuous 10 μs (Min.)～ 8 second (Max.)( Note1),
Variable unit: 1 μs
10 μs (Min.Note1) ～ ∞ (Max.) (Note1)
OFF / Continuous
1 ～ 8
Normal ROI, Multi ROI (1 to 5), Trigger sequence, Command
sequence, Delayed readout
Line Selector (6P): GPIO IN / GPIO OUT
33.5LSB 10-bit (Average value of 100*100)
0 ～ 100 10-bit
±64LSB against Ref. level 10-bit
1 STEP = 0.25LSB
0dB, 6dB, 12dB
0dB ～+24dB (Note2)
OFF / Continuous
Detect white blemish above the threshold value
Complement by adjacent pixels (Continuous blemishes are not
compensated)
256 pixels
AGC and auto exposure can be combined and automatically
0.45, 0.6 and 1.0 (OFF) (3 steps are available)
Choice of Linear or Dark compression ON
OFF: y=1.0, ON=32 points can be set
4 settings, Level 1, 2, 3 and 4
Input range
DC+12V to +24V ± 10% (At the input terminal)
Current
190mA ± 20mA (At 12V input, Full pixels) (Typical)
Power
2.5W (At 12V input, Full pixels) (Typical)
Input range
DC 35 ～ 57V
Current
58mA ±6mA (At 55V input, Full pixels) (Typical)
Power
3.0W (At 12V input, Full pixels) (Typical)
C mount Rear protrusion of the lens is less than 10 mm
17.526 mm, Tolerance: 0 to -0.05 mm
Protection glass: Not provided
-5℃to +45℃ / 20 to 80% (No-condensing)
-25℃ to +60℃ / 20 to 80% (No-condensing)
CE (EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE
29 x 29 x 52 mm (W x H x D) (excluding protrusion)
46g
— 59 —
GO-5000M-PGE-UV
Advertisement
Table of Contents
