JAI GO-5000M-PGE-UV User Manual page 34

Cmos digital progressive scan monochrome uv camera

Hide thumbs Also See for GO-5000M-PGE-UV:

Table of Contents

Multi Frame

In this mode, the AcquisitionStart command captures the number of frames which are specified by

AcquisitionFrameCount.

◆ Normal multi-frame operation

1) AcquisitionStart command is input

2) AcquisitionTriggerWait becomes effective

3) AcquisitionActive becomes "TRUE"(accepts capture)

4) Output N frames as specified by AcquisitionFrameCount

5) AcquisitionActive becomes "FALSE". Then the output stops. (See the following diagram)

Note: This figure is if the trigger is set to ON. When the trigger is OFF,

FrameActive becomes True at the same timing of AcquisitionActive.

Multi Frame operation

◆ Forcing acquisition to stop

While AcquisitionActive is "TRUE", if AcquisitionStop or AcquisitionAbort is initiated,

AcquisitionActive becomes "FALSE" (stop capturing). Once the operation is set to "FALSE", the

internal FrameCount is reset. However, if AcqusitionStop command is initiated during image

output period, AcqusitionActive becomes "FALSE" (stop capturing) after image output is

completed.

Once AcqusitionActive becomes "FALSE", the internal count is reset.

Acqusition Frame Count : Can be set in the range of 1 to 255

— 34 —

GO-5000M-PGE-UV

Table of Contents