JAI GO-5000M-PGE-UV User Manual page 20

Line Format
Indicates the format of the line item selected in Line Selector.
(No Connect, TTL, LVDS, Opt Coupled or Internal Signal)
Note: In the GO-5000M-PGE-UV, TTL and LVDS interface are not equipped.
Action Control
Action control settings allow the use of unicast or broadcast Action Commands as defined in the
GigE Vision 2.0 specification. ACTION_CMD messages received via the GVCP port can control
the camera's internal action signals provided the camera's action control settings match the
settings of the message received. This function is useful for triggering an action in multiple
cameras at roughly the same time. There are two action control inputs on the GO-5000M-PGE-
UV and they are connected to four triggers, counter reset, counter, and timer.
When action control is used, the trigger input source should be set to Action 1 or Action 2 in
advance.
ActionDeviceKey
Sets the device key value for the camera in a 32-bit register. This value must match the
device_key value of the ACTION_CMD message in order for the message to be acted upon.
ActionSelector
Selects Action 1 or Action 2 for setting the action control values.
ActionGroupMask
Sets the mask value for the selected action signal in a 32-bit register. This value is compared
against the group mask value of the ACTION_CMD message to determine if the message should
be ingnored or acted upon. A logical AND operation is used and must produce a non-zero result
or else the message is ignored.
ActionGroupKey
Sets the group key value for the selected action signal in a 32-bit register. This value must
match the group_key value of the ACTION_CMD message in order for the message to be
acted upon.
— 20 —
GO-5000M-PGE-UV