JAI GO-5000M-PGE-UV User Manual page 40

Trigger Selector
Selects the trigger operation. In the GO-5000M-PGE-UV, the following trigger operation can be
selected as the trigger.
Each trigger has the following setting parameters and those parameters are configured on each
trigger selector item.
Setting parameters: Trigger Mode, Trigger Software, Trigger Source, Trigger Activation
Trigger Mode
Select either free-running operation or external trigger operation.
OFF: Free-running operation
ON: External trigger operation
(Initiate the trigger operation selected in Trigger selector)
Trigger Source
The following signals can be used as the trigger source signal.
Trigger activation
This command can select how to activate the trigger.
Rising edge: At the rising edge of the pulse, the trigger is activated.
Falling edge: At the falling edge of the pulse, the trigger is activated.
Level High: During the high level of trigger, the accumulation is activated
Level Low: During the low level of trigger, the accumulation is activated
If Exposure Mode is set to Trigger Width, Level High or Level Low must be used.
Transfer Trigger operation (for delayed readout)
— 40 —
GO-5000M-PGE-UV