JAI GO-5000M-PGE-UV User Manual page 11

② Direct connection（or MP-43 tripod adapter plate）
When mounting the camera directly to a wall or other device, use screws that match the
camera locking screw holes on the camera (M3, depth: 3 mm). Use the supplied screws to
attach the tripod adapter plate.
Caution
For heavy lenses, be sure to support the lens itself. Do not use configurations in which its weight
is supported by the camera.
③ LAN cable
Connect a LAN cable to the RJ-45 connector.
• Use a LAN cable that is Category 5e or higher (Category 6 recommended).
• Use a LAN cable that is STP cable.
• When supplying power via PoE, connect to a PoE-compatible switching hub or a PoE-compatible
network card.
•Refer to the specifications of the cable for details on its bend radius.
Caution
Secure the locking screws on the connector
manually, and do not use a driver. Do not secure
the screws too tightly. Doing so may wear down the
screw threads on the camera. (Tightening torque:
0.147 Nm or less)
④ Network card
Install this in the computer that will be used to configure and operate the camera. As the
camera supports PoE, you can also use PoE-compatible network cards. Refer to the
instruction manual of the network card, and configure settings on the computer as
necessary.
⑤ DC IN / trigger IN connection cable
⑥ AC adapter (power supply) (if necessary)
Connect the AC adapter and the round connector of the connection cable to the DC IN /
trigger IN connector on the camera.
— 11 —
GO-5000M-PGE-UV
Secure manually.
Do not secure too tightly.