Step 3: Verifying Proper Activation And Commissioning; Pre-Commissioning (Off-Grid) - SolarEdge SEK-I Series Installation Manual

Select Monitoring Communication to configure communication with the
monitoring platform.
Select Site Communication to configure communication between multiple
SolarEdge devices or external non-SolarEdge devices, such as batteries or loggers.
Power Control
Power control options are detailed in the Power Control Application Note , available on
the SolarEdge website at:
note_power_control_configuration.pdf.
The Grid Control option may be disabled. Enabling it opens additional options in the
menu.
The Energy Manager option is used for setting power export limitation, as described in
the Export Limitation Application Note , available on the SolarEdge website at:
https://www.solaredge.com/sites/default/files/export_limitation_application_note_
NA.pdf.
For P(Q) diagram refer to:
note_p_q_diagram_of_se_inverters_en_and_na.pdf.
NOTE
SolarEdge inverters with "Grid Support" functionality (as marked on the
inverter certification label), are compliant with UL 1741 Supplement A. The
functionality is built into the inverter and no additional external device is
required.
Step 3: Verifying Proper Activation and
Commissioning
1. Select Information and verify that the correct firmware versions are installed on each
inverter.
2. Select Status and verify that inverter is operating and producing power.
3. Verify that additional configurations were properly set by viewing the relevant
Status screens.
4. Verify that the green inverter LED is steadily lit.
Your SolarEdge power harvesting system is now operational.

Pre-commissioning (Off-Grid)

The following items are required for Pre-commissioning:
Three Phase Inverter with Synergy Technology P/N: SExxK-xxxxIxxxx SExxK-xxxxIxxxx
Chapter 5: Activating, Commissioning and Configuring the System
https://www.solaredge.com/sites/default/files/application_
https://www.solaredge.com/sites/default/files/application_
55