Interface Type - Compuprint MDP40T plus User Manual

Setup Parameter Values

INTERFACE TYPE

parallel, serial, automatic,
auto+blink
INPUT BUFFER 1 Kb, 8 Kb, 16 Kb, 32 Kb
IGNORE PE enabled, disabled
AUTOFEED SIGNAL disabled, enabled
SLCT-IN SIGNAL disabled, enabled
BUFFER CONTROL DTR, XON/XOFF,
XON/XOFF+DTR
ROBUST XON enabled, disabled
WORD LENGTH 7 bit, 8 bit
BAUD RATE 600 - 38400 bps
PARITY BIT Even, odd, none
SECURITY MODE enabled, disabled
Description
Selects the interface type. In case of 'automatic' the interface
type is selected by the printer depending on data coming from
host. When the auto+blink item is selected, the P1 and P2
leds blink to indicate which interface is selected: P1 blinks
when the serial interface is selected, whereas P2 blinks, when
the parallel interface is selected.
Selects the buffer size.
Selects whether the printer signals the paper empty condition
( disabled ) or not ( enabled ).
The parallel interface uses ( enabled ) or does not use
( disabled ) the AUTOFEED signal.
The parallel interface uses ( enabled ) or does not use
( disabled ) the SELECT-IN signal.
Selection of the buffer protocol.
Perform the Robust XON ( enabled ) or not ( disabled ).
Sets the number of the data bits.
Sets the data transfer rate.
Selects the parity control for the data.
Enables or disables the security actions that assure protection
against paper jams. If disabled, the paper handling is faster.
34