Table of Contents
Advertisement
Voyager Operation and Maintenance Manual
g. Measure the same distance for the roll of laminate.
INFORMATION
If not exactly centered, lateral film
adjustment can be made during the
webbing process.
INFORMATION
If the edge of the film is adhered to ink
a oppose to paper, the snapping quality
may be less than acceptable.
© GBC Films Group April 2000
5.4 Adjusting the slitter
Caution should always be exercised
adjusting the film slitter.
Sharp blade can cut you!
For application where the film is too wide, slitter
is provided to cut the film to the correct width as it is
pulled off the film roll.
To position the slitter, take the following steps:
a. Determine the distance from the left-hand inner face of
the laminator to the point on the sheet where you want the
drive side edge of the film to lie.
Application
WARNING
Page 1 - 33
Advertisement
Table of Contents
