GBC VOYAGER Instruction Manual page 13

Voyager Operation and Maintenance Manual
Emergency Stop Button
Pressing this button causes the laminating and pull
rollers to separate and all the rollers to stop.
Nip Pressure Controls
The "On-Off" switch applies air pressure to the
laminating rollers. The adjusting knob varies the pressure,
and the gauge shows the air pressure.
FWD/REV Controls
This switch is used to reverse the roll direction
for ease of cleaning and maintenance.
© GBC Films Group April 2000
Speed Control
Turning the knob adjusts the speed at which the
rollers turn.
Upper Roll Temp Controller
This unit displays the actual chrome roller
temperature and also allows the operator to adjust the
operating temperature of the heat roller, up or down.
Main Power Switch
Switches on or off, all the power to the laminator
and heating unit.
Introduction
Page 1 - 11