GBC VOYAGER Instruction Manual page 38

Application
5.6 Threading
Before you thread the film around the heat roller,
confirm that the roller is not too hot for your film and the
nip pressure and film tension are at reasonable settings
for beginning your lamination.
GBC Films Group recommends that you use the
following procedure to thread the film through the
laminator. Threading may be done in other ways, but this
method keeps the film from wrapping around a pull roller,
and it is especially appropriate if one person alone must
start the operation.
To thread the laminator, take the following steps:
a. Switch on power at the Main Power Switch.
Page 1 - 36
Voyager Operation and Maintenance Manual
b. Set the temperature for the heat roller.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
c. When the heat roller has become hot enough to laminate
the film, raise the heat roller safety shield.
CAUTION! Heat roller is HOT !
© GBC Films Group April 2000
WARNING
CAUTION