Table of Contents
Advertisement
Troubleshooting
Chart 7.1 Troubleshooting chart
Trouble
1. Table will not automatically
compensate in run mode.
2. Feed head will not pick up
or advance sheets.
3. Lay Varying
Page 1 - 46
Voyager Operation and Maintenance Manual
Cause / Action
a. Top of paper stack is not breaking light beam
b. Stack too low to gate - Raise head
a. Spring clips, brushes not allowing suction cups to lift, reducing
amount of grip
b. Blower air on foot needs to be increased by opening valve,
air must slightly lift leading edge of sheet.
c. Vent hole on air pump is plugged, reducing the vacuum -
clean it.
d. Check for disconnected or broken air lines
e. Missing or cracked suction cups
a. Vacuum on feed table needs to be adjusted up or down.
b. Upper infeed wheels not properly adjusted to head stop.
Adjust them so that the infeed wheels contact lower infeed wheels
when the the head stops are flush within feed tray. Wheels must
spin with little contact.
c. Sheet paddles allowing paper to hop over head-stops or
causing the sheets to stop at head-stops before the wheels come
lower.
d. Loose drive chains - check and tighten.
e. Worn or broken drive train parts on the feeder or on the
laminator - Replace.
© GBC Films Group April 2000
Advertisement
Table of Contents
