GBC VOYAGER Instruction Manual page 34

Application
b. Lift the upper unwind arm and secure with the latch.
c. Swing the unwind arm out enough for you and another
person to load the roll of film. refer to image above.
d. Remove the one core end and the core gripper.
Always use safe and proper lifting practices
when lifting heavy objects. You can become
seriously injured or crushed.
e. Slide the roll of film on the unwind shaft with regards to
the laminate used.
Page 1 - 32
WARNING
Voyager Operation and Maintenance Manual
f. Place the unwind arm back into its saddle and lower
the upper unwind arm.
f. To correctly position the left edge of the film, measure
the distance from the left-hand inner face of the laminator
to the edge of the sheet.
If the edge of the film is set in too far
from either edge of the sheet, the sheet
may be damaged due to insufficient
mechanical support from the film.
© GBC Films Group April 2000
CAUTION