Page 1
Ultima 35 EZload Laminator User's Manual Provided By http://www.MyBinding.com http://www.MyBindingBlog.com...
Page 2
Instruction Manual Manuel d’utilisation Manual de instrucciones To Register this product go to www.gbc.com Pour enregistrer ce produit allez sur www.gbc.com Para registrar este producto entre en www.gbc.com...
YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT TO WARNING: FOR YOUR PROTECTION, DO NOT CONNECT GBC. IN THIS INSTRUCTION MANUAL AND ON THE PRODUCT ARE THE LAMINATOR TO ELECTRICAL POWER OR ATTEMPT IMPORTANT SAFETY MESSAGES. READ THESE MESSAGES CAREFULLY.
Do not attempt to service or repair the laminator. Unplug the unit and contact an authorized GBC service representative for any required repairs or one or more of the following has occurred: • The power supply cord or attachment plug is damaged.
Features Guide A. POWER SWITCH: I. NIP ROLLERS: (figure 3b) Located at the back of the machine, applies power to the laminator. The Nip Rollers are located behind the heat shoes. The nip point is The ‘ON’ position is indicated by the ‘ ’ symbol. The ‘OFF’ position where the heated film is compressed and pulled through the marked ‘...
) to the ‘RUN’ ) position. Slide the threading card (provided with new rolls of GBC laminating film) on the feed table, gently pushing the film into the nip rollers (figure 10). The threading card should now be guiding both rolls of film through the laminator.
Operation Specifications Ultima35 EZLoad CAUTION: MAKE SURE HEAT SHIELD AND FEED TABLE Operating Speed 3 fpm ARE IN THE PROPER POSITION TO OPERATE THE UNIT. Dimensions (W x L x H) 16.929 x 18.11 x 11.142 inch Move the Main Power switch to the ‘ON’ ( ) position (figure 1). Weight 35lbs With the main power switch in the ‘ON’...
Page 11
General Binding Corp. Northbrook, Illinois 60062, USA www.gbc.com...