Cleaning And Maintenance Of The Device; Cleaning The Central Brush - Polaris PVCR 1028 WI-FI IQ Home Operation Manual

insert the accumulator plug into the power socket on the vacuum cleaner until the click. Carefully position
the accumulator inside the compartment avoiding jamming connective wires.
5. Put the battery compartment lid back on its place. Tighten the screws.

CLEANING AND MAINTENANCE OF THE DEVICE

7. Prior to cleaning and maintenance, make sure to disconnect the device from the charger, and to disconnect
the charger from a power network.
8. Do not dip the device or the charger into water or any liquids.
9. Do not use petrol, alcohol, and chemical solvents during cleaning the device.
10. Metal components of the device shall be wiped with a clean dry piece of cloth.
11. Plastic components of the device shall be wiped with a wet wrung piece of cloth. No water droplets are
allowable.
12. The device shall be stored in a dry cool place.
CLEANING THE DUST BAG (Fig. 18)
Each time after vacuuming:
- Press the dust bag latch, and pull downward,
- Take out the container by pulling it outward.
- Check for foreign items clogging the channels. If any, remove them.
- open the lid by pulling the latch downward,
- Flip the container upside down and shake any debris out of it.
- To extract and replace HEPA-filter you should release the latch on the dust bag lid. Empty the HEPA-filter by
way of shaking out, or by means of special brush. If necessary, rinse the HEPA-filter under a thin jet of water.
Fig. 19
- Dry out the filters and dust bag before installation.
- Install the filters,
- Close the container and install it on its place.

CLEANING THE CENTRAL BRUSH

The electric brush is intended for collection of household dust from the floor and carpets by means of a
rotating bristle roller. Its design is quite a susceptible to clogging with long hairs, wool, threads etc. In case of
clogging, you should immediately cease vacuum cleaner operation, and take measures for cleaning the bristle
roller. The cleaning should be performed each time after vacuuming.
The roller has got a separate electric drive which engages simultaneously with the vacuum cleaner motor.
To clean the roller: (Fig. 20)
1. Turn off the device through I/O switch (by setting it to "O" position).
2. Flip the vacuum cleaner so that its rear part faces toward you.
3. Given a small amount of hairs and threads having wound around the bristle roller, they can be cut away with
a knife without detaching the bristle roller. For this, position a sharp knife between rows of bristles so that
the sharp edge of the knife faces outward from the roller, and then move the knife along the roller to cut any
hairs and threads wound around it. Then, any hair trims can be easily removed out of the brush body; for
your convenience it is allowed to manually rotate the bristle roller around its pivot axis.
4. Given a severe clogging of the bristle roller, detach the electric brush roller retention frame by a slight
outward exertion on the retainer latch plates, and lift the near end of the frame, then take out the frame.
5. Slightly lift the right end of the bristle roller by pulling to the right, then unlatch it from the drive, and take it
out of the socket. Having the bristle roller taken out of the body, use a knife or scissors to easily clean the
roller from any hairs and threads wound around it.
6. Installation of the bristle roller back to its place in the brush body shall be performed in the reverse manner.
7. Given a severe clogging of components of the brush and electric drive, contact an authorized service center
for disassembling and cleaning.
CLEANING THE LATERAL BRUSHES (Fig.21)
6. Turn off the vacuum cleaner.
7. Check the brushes for any defects and / or foreign items, as well as debris having wound around.
36