Accumulator Replacement; Cleaning And Maintenance Of The Device; Cleaning The Dust Bag; Each Time After Vacuuming - Polaris PVCR 3200 IQ Home Aqua Black Operation Manual

There shall be no obstacles at a distance of 1 meter from two lateral sides, and at a distance of 2 meters from the
front side of the charging base. At the base location area, there shall also be no mirrors and intensively reflecting
surfaces within 15 cm heightwise from the floor. In case of presence of such surfaces, they shall be blanketed.
Do not place the base against a window if exposure to direct solar radiation is possible. (Fig. 16)
To start charging, move the power switch to the ON position, and put the vacuum cleaner on the base. Make sure
that contact leads on the base align with contact leas on the device.
Fully charged / under the cleanup mode
Turned off / under Sleep mode/ charged a long ago
Do not leave the adapter unattended if energized after charging.
Do not leave the charging base on the floor for long when not in operation.
Attention! In is strictly prohibited to short-circuit the leads of the charging base!
Prior to a long-term storage, discharge the accumulator to the half. Do not keep the accumulator under
subzero ambient temperature.
ACCUMULATOR REPLACEMENT (Fig. 17)
1. Turn off the device through the power switch.
2. Position the device so that its bottom panel faced upward.
3. Use a cross screwdriver (beyond the delivery set) to unscrew the screws of the battery compartment lid, and
remove the lid by prying it up from the screws location side.
4. Take out the depleted accumulator from its compartment, and disconnect its socket by pressing the power
socket latch on the vacuum cleaner, and pulling out the accumulator plug. To connect a new accumulator,
insert the accumulator plug into the power socket on the vacuum cleaner until the click. Carefully position the
accumulator inside the compartment avoiding jamming connective wires.
5. Put the battery compartment lid back on its place. Tighten the screws.

CLEANING AND MAINTENANCE OF THE DEVICE

1. Prior to cleaning and maintenance, make sure to disconnect the device from the charger, and to disconnect the
charger from a power network.
2. Do not dip the device or the charger into water or any liquids.
3. Do not use petrol, alcohol, and chemical solvents during cleaning the device.
4. Metal components of the device shall be wiped with a clean dry piece of cloth.
5. Plastic components of the device shall be wiped with a wet wrung piece of cloth. No water droplets are
allowable.
6. The device shall be stored in a dry cool place.
Pre-operation preparation of the wet cleaning container
Attention! If the wet vacuuming is ceased until the program completion (to add water) the vacuum cleaner
operation resumption can start from cleaning an area having already been vacuumed. Do not use the wet
vacuuming when cleaning a carpet.
Make always sure to timely add fresh water into the container, and make always sure to empty the container
after cleaning. Remove this container prior to charging the accumulator.
Prior to pouring water, follow the Figure to position at the container bottom the rag being a part of the delivery
set. (Fig. 7)
Pouring water.
Open the intake orifice lid, carefully pour fresh water until it reaches the upper mark. Tightly secure the lid.
CLEANING THE DUST BAG (Fig. 18)

Each time after vacuuming:

- Press the dust bag latch, and pull downward,
- Take out the container by pulling it outward.
- Check for foreign items clogging the channels. If any, remove them.
- open the lid by pulling the latch downward,
- Flip the container upside down and shake any debris out of it.
- To extract and replace HEPA-filter you should release the latch on the dust bag lid. Empty the HEPA-filter by
The device status
Under charging
Low-charged battery
Shows an error
86
Indicator color
Pink, glittering
Blue+pink, steady illumination
Blue, steady illumination
Dim
Red