Charging The Accumulator Without Using The Charging Base; Accumulator Replacement; Cleaning And Maintenance Of The Device - Polaris SmartGo PVCR 0930 Operation Manual

Do not leave the adapter unattended if energized after charging.
Do not leave the charging base on the floor for long when not in operation.
Attention! In is strictly prohibited to short-circuit the leads of the charging base!
Prior to a long-term storage, discharge the accumulator to the half. Do not keep the
accumulator under subzero ambient temperature.
2.

CHARGING THE ACCUMULATOR WITHOUT USING THE CHARGING BASE

Prior to charging the accumulator, the vacuum cleaner shall be turned off. Turn off the device
by moving the I/O switch on the device body to the "O" position.
Insert the adapter plug into the power socket on the vacuum cleaner body.
Connect the adapter to a power network. This causes glittering the
orange. The battery icon on the display indicates the charge level.
Once the charging is completed, the
indicator is dim this means that the vacuum cleaners has been charged long ago.
Disconnect the adapter from the power network and from the vacuum cleaner. Do not turn off
the charger until the accumulator is fully charged.
Note:

If the device is idle for long, it is recommended to check the accumulator charge level at the
indicator on the display in every 3 months. It is recommended to keep the accumulator half-
charged (to two thirds according to the indicator). If the accumulator charge level decreases
during storage, it is recommended to carry out a drill having preliminarily discharged the
accumulator completely what requires continuous operation of the device for as long as possible.
Then, it shall be charged to the full followed by operating the device until having the accumulator
half discharged.

You are advised to charge the accumulator only when the device signals about its upcoming
discharge, or when having it fully discharged. When fist-ever used, an accumulator can ensure
autonomous operation of the device for up to 200 minutes. This value can decrease with time.
A depleted accumulator shall be disconnected and disposed as per local legislation and
regulations.

ACCUMULATOR REPLACEMENT

1. Turn off the device through the power switch.
2. Position the device so that its bottom panel faced upward.
3. Use a cross screwdriver (beyond the delivery set) to unscrew the screws of the battery
compartment lid, and remove the lid by prying it up from the screws location side.
4. Take out the depleted accumulator from its compartment, and disconnect its socket by pressing
the power socket latch on the vacuum cleaner, and pulling out the accumulator plug. To connect
a new accumulator, insert the accumulator plug into the power socket on the vacuum cleaner
until the click. Carefully position the accumulator inside the compartment avoiding jamming
connective wires.
5. Put the battery compartment lid back on its place. Tighten the screws.

CLEANING AND MAINTENANCE OF THE DEVICE

1. Prior to cleaning and maintenance, make sure to disconnect the device from the charger, and to
The device status
Under charging/ Low-charged battery
Fully charged / under the cleanup mode
Turned off / under Sleep mode/ charged a
long ago
Displays an error
button indication starts illuminating in green. If the
28
Indicator color
Orange, glittering
Green, steady illumination
Dim
Red
button indicator in