Sierra Wireless AirPrime XS1110 Command Reference Manual page 31

Table 3-2: Other Commands (Detail)
Command
AT+GNSSTHRES
Rev 3.1 Jul.20
Command reference
Description
Configure and query the GNSS threshold
Usage:
•
Write (<action> = 2):
AT+GNSSTHRES=<action>,<ID>
Response: +GNSSTHRES,< action >,<ID>,OK
or +GNSSTHRES,<error code>
Purpose: Set the default threshold value for positioning.
•
Write (<action> = 3):
AT+GNSSTHRES=<action>,<threshold_mode>,<value>
Response: +GNSSTHRES,<action>,<threshold_mode>,<value>,OK
or +GNSSTHRES,<error code>
Purpose: Set the threshold for positioning.
•
Read: AT+GNSSTHRES?
Response: +GNSSTHRES,<CNR>,<elevation>,<reserved><horizontal>,<HDOP>,
<static_states>,<height>,OK
or +GNSSTHRES,<error code>
Purpose: Get all threshold values.
Parameters:
<action> (Status of configuring threshold)
•
2—Erase
•
3—Set
<threshold_mode> (The mode of threshold)
•
0—All threshold
•
1—CNR
•
2—Elevation
•
3—Used satellite
•
4—Horizontal accuracy
•
5—HDOP
•
6—Static states
•
7—Height
<CNR> (Minimal C/N Ratio) (unit: dB-Hz)
•
Minimum satellite CNR value to be used for positioning
•
Default: 0 dB-Hz
•
Valid value: 0-50
<elevation> (The minimal elevation) (unit: degree)
•
Minimum satellite elevation value to be used for positioning
•
Default: 5 degrees
•
Valid value: 0-90
(Continued on next page)
31
Other Commands
41113737