Sierra Wireless AirPrime XS1110 Command Reference Manual page 13

Table 2-2: General Commands (Detail) (Continued)
Command
AT+GNSSSATE
Rev 3.1 Jul.20
Description
Configure and query GNSS search mode
Note: Confirm which search modes are supported by your firmware.
Usage:
•
Write: AT+GNSSSATE=<GP>,<GL>,<GA>,<Reserved>,<BD>,<QZ>,<SBAS>
Response: +GNSSSATE,<GP>,<GL>,<GA>,<Reserved>,<BD>,<QZ>,<SBAS>,OK
or +GNSSSATE,<error code>
Purpose: Configure module to use specified satellite.
•
Read: AT+GNSSSATE?
Response: +GNSSSATE,<GP>,<GL>,<GA>,<Reserved>,<BD>,<QZ>,<SBAS>,OK
or +GNSSSATE,<error code>
Purpose: Acquire current satellite system used for positioning.
Parameters:
<GP> (GPS configuration). Note that the GPS is mandatory, it is always enabled.
•
1—Enable
<GL> (GLONASS configuration)
•
0—Disable
•
1—Enable
<GA> (Galileo configuration)
•
0—Disable
•
1—Enable
<Reserved> (Reserved field)
<BD> (BeiDou configuration)
•
0—Disable
•
1—Enable
<QZ> (QZSS configuration)
•
0—Disable
•
1—Enable
<SBAS> (SBAS configuration)
•
0—Disable
•
1—Enable
Note: Refer to Table 2-4
Examples:
•
Change search mode to GPS+GLONASS+QZSS:
AT+GNSSSATE=1,1,0,0,0,1,0<CR><LF>
+GNSSSATE,1,1,0,0,0,1,0,OK*3F<CR><LF>
•
Read search mode:
AT+GNSSSATE?<CR><LF>
+GNSSSATE,1,1,0,0,0,1,0,OK*3F<CR><LF>
for details on satellite settings
13
General Commands
41113737