NEC UNIVERGE DT920 Series User Manual page 35

TO SET A LANGUAGE
The procedure below shows how to set a language to be
displayed on LCD.
1.
Press Menu key while terminal is in an idle state.
□
2.
Select 1 User Settings.
□
3.
Select 3 Display.
□
4.
Language
Select 5
5.
Select a desired language.
For example, press [1] + [3] to select
The enabled item is highlighted.
Each item is displayed in its native language as follows:
6.
After the selection is completed, press Enter key
or the OK soft key.
.
□
13 English.
TO ENABLE/DISABLE BACKLIGHT
FADE CONTROL
The procedure below shows how to enable/disable the backlight
fade control.
The backlight fades in or fades out when this setting is enabled.
1.
Press Menu key while terminal is in an idle state.
□
2.
Select 1 User Settings.
□
3.
Select 3 Display.
□
4.
Select 6 Advanced.
□
5.
Select 1 Backlight Fade Control.
6.
Select desired setting from the following list.
No. Menu Item
Backlight fade control of LCD is
1 Disable
disabled.
Backlight fade control of LCD is
2 Enable
enabled (default).
The enabled item is highlighted.
35
TERMINAL SETUP
Meaning