Remote Telephone Messages - MCK EXTender 6000 Quick Installation Manual

Remote Telephone Messages

The following messages appear on the remote telephone display connected to the Remote Unit when a
connection attempt fails. The telephone shows Connect Error, followed by a message. Table 9:
Connect Error Messages, on the next page, contains the possible Connect Error messages.
Table 9: Connect Error Messages
Message
Already connected
Assigned port
Busy (see note)
Assigned port
Down (see note)
Carrier Lost
(see note)
Connect rejected
Connect Timeout
Network disabled
Network down
Network in use
Network not ready
No bandwidth
Normal take down
No Voice path
(see note)
Peer disconnect
Note: This message is not preceded by "Connect error".
EXTender 6000 Quick Installation Guide
Description
Remote port is already connected.
The switch port is being used by
another user.
The switch port is not available, due
to problems (green flicker) with the
port.
Displayed if the network connection
to the PBX is lost.
The system rejects the connection
request.
The EXTender cannot connect to
the
PBXgateway.
The network device is not
connected, being used, or is not
active.
The network device has a problem.
The network device is being used by
another device.
The network device is not ready for
use. (yellow LED)
The unit bandwidth is
oversubscribed. No network
bandwidth is available for telephone
signaling
Displayed when the network device
is either being rebooted or reset.
The unit bandwidth is
oversubscribed. No network
bandwidth is available for voice.
Displayed when the Switch unit has
disconnected from the network
device.
Action
Reset port at the Gateway.
Wait until port is available or
reset port on the
PBXgateway and try to re-
connect.
Check port connection at the
PBXgateway.
Check network links.
Attempt to reconnect after
network is up and running.
Make sure the Connect
Password is correct.
Check network links.
Attempt to reconnect.
Check WAN connection on
the unit
Check network link and
device.
Check network link and
device.
Reset WAN and try to re-
connect.
Make sure primary connect
matches "enabled" WAN port.
Change voice compression.
Wait until the WAN link LED
is solid green, and then
attempt to re-connect.
Change voice compression.
Check the voice compression
or network at the
PBXgateway.
34