Wan Mode; Procedure; Setting The Async Parameters - MCK EXTender 6000 Quick Installation Manual

WAN Mode

The EXTender utilizes a direct serial connection to provide remote user connectivity. This means that the
WAN port is plugged directly into a network device. The WAN port (WAN 1 or WAN 2) that is used as the
main or "primary" port must be set for Async Mode.

Procedure

1. Access the WAN Menu from the Main Menu using the following path:
Path: Remote->Configuration->WAN ->WAN 1 or WAN 2
The WAN 1 menu appears.
2. Press the key
required.
3. Press the key to select the Async-RS-232-Dial value.
key to accept changes and go back to the Configuration Menu. Press the ← key to the
4. Press the
Save option. Press Enter.

Setting the Async Parameters

Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path;
Path: Remote->Configuration->WAN 1 or 2->Async_Setup
The following menu appears.
EXTender 6000 Quick Installation Guide
Figure 14:
key to the Mode parameter. This sets the WAN port to the async protocol
Figure 15:
WAN Menu
Asyc_Setup Menu
26