Table of Contents
Advertisement
Installation Environment
This section provides the necessary information to configure the EXTender using the MI. The
units are programmed at the factory with "default" settings providing basic parameters to
accommodate most network environments.
Which type of
Before beginning the configuration process, identify the network device type
Network
that is connected to the EXTender. Once you know the connection type, use
Device do you
Figure 4: Back of Unit (LAN Connections), to determine the appropriate
have?
checklist to use for configuration.
Table 5:
Network Devices
To configure the EXTender with.......
a Synchronous -serial device via WAN Port(s) 1 or 2 (RVP_Direct) using one of
the following protocols:
•
V. 3 5
•
RS-232
•
RS-530
an Asynchronous -serial device via WAN Port(s) 1 or 2 (RVP_Direct) using RS-
232 Protocol.
an IP device – via Ethernet port (RVP_IP).
* MCK's IP-based products utilize VOIP technology to deliver remote voice
solutions. The voice quality of these solutions is dependent on variables such as
available bandwidth, network latency and quality of service (QoS) initiatives, all
of which are controlled by the network and internet service providers. Because
these variables are not our control, we cannot guarantee the performance of the
user's IP-based remote voice solution.
EXTender 6000 Quick Installation Guide
See......
Page 19
page 24
page 30
18
Advertisement
Table of Contents
