Table of Contents
Advertisement
4. Press the
and
Suspend mode when no activity occurs for the set Timeout value. Set the value between 15 and 240
minutes
5. Press the
and
enable wakeup from Call Suspend on activity at the Branch site only (for example, when a telephone
set goes off-hook or a key is pressed). If you set this parameter to No (disabled), incoming calls can
also cause wakeup from Call Suspend.
6. Press the
and
port. The choices are Ring, or Lamp.
Note: Use Ring mode for non-ACD sets, and use "Lamp" for ACD sets.
7. If you have selected Lamp mode for any ports, press the
This parameter sets the Lamp indicators that you want to monitor on the telephone.
Note: Normally you should select call-appearance Lamps.
8. If the Remote has ACD sets with Headsets, press the
Enable the ACD Tone for each port that has an ACD telephone with Headset.
9. Press the
and
value for a connection from the Gateway to Remote or Remote to Gateway.
10. Press the
key to accept changes and go back to the Configuration Menu.
11. Press the
key to the Save parameter. Press Enter to save changes to the active config (.rem) file.
Note: Make sure the "Dial-up" and "Dialback" numbers are programmed.
EXTender 6000 Quick Installation Guide
key to the Timeout parameter. This parameter causes the units to go into Call
key to the Remote Only Wakeup parameter. If you set this parameter to Yes, you
key to the Mode parameter. This sub-menu sets the Call Suspend mode for each
key to the Remote Login Timeout parameter. This parameter sets the timeout
and
key to the Indicators parameter.
and
key to the ACD Tone parameter.
41
Advertisement
Table of Contents
Need help?
Do you have a question about the EXTender 6000 and is the answer not in the manual?